1. The Forum Rules have undergone some minor changes and updates.  Please take the time to read them; it will only take a couple of minutes of your time. By doing so, you lessen the chance of incurring the wrath of the moderation team or making yourself look foolish to other members.

    90% of users posting adverts in the Sales forums need to be reminded to read the rules as their posts are wrong.  This is unnecessarily time-consuming and will no longer happen - if your advert doesn't follow the Sales Rules it will be deleted and you'll have to start all over again.

    To close this box once you've read it (and the Rules), click on the X in the top right-hand corner.

    Thank you.

    AGF Staff



    Dismiss Notice
  2. A reminder of one of the Forum Rules:

    'Behaviour

    Do not make inappropriate or offensive posts - including threats, harassment, swearing, prejudice, defamation, deliberate insults or name-calling, other negative remarks about this forum, its moderators and administrators or your fellow members. Even if this is just your own personal opinion, RESPECT YOUR FELLOW MEMBERS.'

    There have been changes made to our censoring software in an attempt to help with this growing problem.

    Click the X in the top-right-hand corner to dismiss this notice.
    Dismiss Notice
  3. Dear members,

    Our membership (like our country) consists of people from all walks of life; different in far more ways than can be listed here and each with a different view based on their experience of life - regardless of their colour, religion or cultural heritage. Every single person in the UK has been born of mixed race – we are a multi-coloured and multi-cultural country.

    As many of you are aware there are a handful of individuals amongst this membership that persist in making provocative, inflammatory, racist and otherwise offensive comments. This has been happening across the forum to a certain degree but is most especially prevalent in the Adult section.

    The moderation team has tried to stay on top of this, however unfortunately because of the ‘offensive’ nature of much of its content we don’t monitor the Adult section quite as much as perhaps we should. As a result much of this behaviour has gone unnoticed unless it has been reported to us. While the team always intended to take a "light touch" approach to the Adult section it would seem that some people aren’t quite adult enough to be left unmonitored after all.

    This behaviour is, and always has been against Forum Rules as well as the specific stipulations of the Adults forum and it will no longer be tolerated. We feel it's time to draw a line in the sand and as such from this point onward offenders will receive an immediate and permanent ban from the forum.

    In order for us to achieve our goal of restoring the forum to the friendly and tolerant place it once was, we ask that ALL members be mindful of the content they post and help us to stop unacceptable behaviour by using the 'Report' tool at the bottom of any offending post - the results of which can be seen only by Admin/Moderators.

    You should all receive a copy of this message by PM. 

    To close this message box, click on the 'X' in the top-right-hand corner.

    Dismiss Notice
  4. Hotmail block emails from us entering your inbox. Unless you can setup a safe sender you will not get activation emails from the forum. Please use an alternative provider or complain to Hotmail.
    Hotmail addresses include.

    @Hotmail.co.uk @Hotmail.com @outlook.com @Live.com
    Dismiss Notice
  5. Postings on Politics, Religion & Controversial Off-Topic Material

    The majority of users do not want to read about these subjects and people have left the forum as a result of it – this is after all an 'Airgun' Forum. It’s all very well to say they don’t have to read it if they don't want to, but as most of us use the ‘New Posts’ button there is no easy way to avoid it.

    All AGF staff members are in favour of people being able to discuss what they want, but we have to draw the line somewhere if it is upsetting other users. We don’t want to read about these topics either.

    IMPORTANT- The discussion of politics and religion is no longer allowed anywhere on the forum (including the Adult section).  The only exception is if it's airgun related - they must be put in the Airgun Related Politics section..

    We will not tolerate bullying or personal attacks, racism or any other offensive 'isms'. we will remove these topics from the forum, we will not give you an area where you can abuse each other. We will not hesitate to ban offenders.

    To clear this text box, click on the 'X' in the top right-hand corner.

    Dismiss Notice

(Withdrawn) Logun Solo .177.

Discussion in 'Sales Graveyard' started by Stu83, Jun 24, 2012.

  1. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    Hi just seeing if there is any interest in my Logun solo .177, it has the 10 shot mag, single shot tray, its been converted to a rear bolt handle but can be used as a side bolt too, A stainless steel filler probe and has a umarex silencer.

    The rifle is putting out 11.44ft/lbs on the last test it had, think it was bisley hollow points it was tested with.

    Bad points the air cylinder has two marks on it and on one side of the stock a piece of the wood had fell off at a knot part, if that makes sense:)

    After something a bit smaller like a single shot ultra maybe a hatsan at44-10 in thumbhole plastic stock or whatever pcp really not too fussed.

    Feel free to ask questions:D

    Forgot to mention it has the Lothar Walther choked barrel. Also been depinged.

    2012-06-12 01.52.09.jpg 2012-06-12 01.52.51.jpg 2012-06-15 17.16.46.jpg 2012-06-15 17.18.04.jpg 2012-06-15 17.18.30.jpg
     
    Last edited: Jun 25, 2012
  2. panda32

    panda32 Member

    Messages:
    22
    Likes Received:
    0
    Location:
    essex
    I have a hatsun at44-10 shot 177 in real tree very nice, when you say a peice of the stock fell off how bad is it ?
     
  3. toytown

    toytown Honorary Member

    Messages:
    2,574
    Likes Received:
    0
    Location:
    Surrey
    looks like the corner bellow the rear bolt in pic 2 unless thats the cut out made for the bolt conversion

    is the barrel band secure or is the tape for something else?
     
  4. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    The corner of stock is for the rear bolt, the tape is stop the barrel rattling off the barrel band, logun didnt quite make the barrel flush at the top :) the bit that fell of is about 4mm long by 2mm its part of a knot in the wood.

    ill take a pic of the bit that fell out.

    2012-06-24 19.21.35.jpg 2012-06-24 19.21.51.jpg

    any takers?
     
  5. toytown

    toytown Honorary Member

    Messages:
    2,574
    Likes Received:
    0
    Location:
    Surrey
    easily fixed mate, ive repaired worse lol. would you sell it
     
  6. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    Not sure how much its worth:)
     
  7. toytown

    toytown Honorary Member

    Messages:
    2,574
    Likes Received:
    0
    Location:
    Surrey
    is it rifle and mod or is scope in the deal too
     
  8. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    Id prefer to keep the scope as its new but will sell it with rifle if need be.
     
  9. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    to the top:D
     
  10. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    last bump to the top :D
     
  11. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    maybe willing to sell but unsure of price but will post.
     
  12. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    No one interested then? give it till the end of the weekend then I'll withdrawn.:)
     
  13. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    Bump to the top:D
     
  14. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    bump....:)
     
  15. Ronnieman

    Ronnieman Engaging Member

    Messages:
    491
    Likes Received:
    0
    Location:
    Malvern
    Fancy a swap + cash for my hw100 .177 it's in the sales section? Cheers
     
  16. slingshot

    slingshot Engaging Member

    Messages:
    229
    Likes Received:
    6
    Location:
    Harlow
    is the barrel threaded to take a mod or do you have to use adaptor or slip on mod

    cheers Andy
     
  17. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    barrel is threaded as standard:)
     
  18. Stu83

    Stu83 Engaging Member

    Messages:
    338
    Likes Received:
    0
    Location:
    Stockton-on-Tees
    Withdrawn.

    Stu.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice