Brass & alloy HW95 / HW98 Stock cups & bolts & safetys

[welshwilly]

payment sent for above, ...

Thank you, I will post tomorrow
ATB
Will.

[Irvysan]

I am probably being daft but i have a question about these :

the original screw has a smooth washer that sits against the stock then a locking washer

should i fit a washer between the cup and the stock????

obviously im not going to use the locking washer as it will chew up the stock but if i fit both its not flush

if i fit this with NO washers will it need tightened often (i have a springer HW95) < thats what i have done at the moment

thanks in advance troops

Irv

Its a 3mm allen key for those who are wondering/dont have one. < that will save you buying a set like i did

If this question doesnt make sense i will get the camera oot!

[welshwilly]

You shouldnt need any washers at all Irv, just place a small drop of super glue on the thread and it will be fine, the bolts shouldnt come loose.

Will.

[Irvysan]

You shouldnt need any washers at all Irv, just place a small drop of super glue on the thread and it will be fine, the bolts shouldnt come loose.

Will.

Im not using any washers atm.

So superglue or loctite then?

Thanks will

Sent from my GT-I9100 using Tapatalk

[kieron]

Hi mate,brass safety for HW85,pm to follow

[kieron]

It's for an 85 but 95/98 will do

[welshwilly]

It's for an 85 but 95/98 will do

Pmd you back Kieron

Will.