Home
Forum
What's New?
LinkBack URL
About LinkBacks
Reply With QuoteCarefelly cut a small slot it it useing a dremel or something similar then get it out with a flat blade screwdriver.
******** aint they??
This is a discussion on ratcatcher breech screw within the Anything Airgun Related forums, part of the Airguns category; any hints on getting a knackered breech screw out of a king ratcatcher? don't know what possessed crosman to put ...
any hints on getting a knackered breech screw out of a king ratcatcher?
don't know what possessed crosman to put such a piddly little allen screw in there
i used the correct allen key and it would not budge,used a bit of force and its rounded off and i can't get the bugger out
any suggestions much appreciated
will drill it out only as a last resort
Carefelly cut a small slot it it useing a dremel or something similar then get it out with a flat blade screwdriver.
******** aint they??
Shot Many 0000's of Rats, Shame very few ever lived long enough to tell the tale of the great rat killer....
Banned From the darkside and proud:
Coz I was too Damn Good!
Best new member '09
Most Helpfull '10
what i done was when i rounded it off,was i got a small phillips bit hammered it carefully into hole until it gripped then carefully turned it,i didn't have a dremmel so that's how i got it out.
thanks for the repliesthe allen screws are shite
will try your suggestions,now where did i put my dremel
Crosman bolts are best quality cheese. I find a torx screwdriver can often be hammered in sufficiently to grip.
did think of a torx but i don't have one small enough
a trip to maplns may be needed
Posting Permissions
