Putting the Daystate magazine back together

[Andy]

Here's what you should have in front of you once the magazine is stripped.




First you need to push the pin flush on the inside of the magazine body.



Then put the rotor in the body with the red dot facing the bottom of the magazine, insert the main spring into the rotor (locating the spring end in the tiny hole in rotor)
Install the spawl and small spring as in this picture.



Holding everything in place, you then need to install the backing plate. (making sure the spring end goes in the tiny hole in the backing plate)



Once this is back in place put the allen screw back in front of the magazine and tighten.

Then rotate the rotor 12 holes or clicks anticlockwise then just push the pin on front of the magazine flush again, so that is flat against the front surface.



Job done.

Copyright © Airgunforum.co.uk 2012. All Rights Reserved.

[arrows180]

Nice work Andy and much appreciated.

[Calibre]

Thanks Andy ....very,very informative

[markh]

Andy

You are nothing short of a GENIUS !!!

How the hell you managed to find all that out I just don't know, I however have a little issue in respect that I haven't got the spawl spring. Guess you were lucky to have found yours I wasn't so lucky !!!!

Will see if Daystate could possibly send me one fingers crossed !

[bobbyboy]

nice one

[blacky]

Good pics and info.

[sniper22]

now try a 20 shot mag

[markh]

Andy,

Just wanted to say MANY MANY thanks I have now managed to re-assemble the magazine.

Keep up the good work you are a god send to us all !!! creep, creep

[Andy]

Andy,

Just wanted to say MANY MANY thanks I have now managed to re-assemble the magazine.

Keep up the good work you are a god send to us all !!! creep, creep

How much was the spring.

[markh]

How much was the spring.

Can't say